Best Darn Homebrew Store in Georgia!


Chugger-SS Inline


$149.99

Add to Cart:


  • Description
  • Details
  • Reviews
The CHUGGER PUMP® Stainless Steel Inline Pump 115V is a homebrew beer pump which is typically used to transfer hot and/or cold liquids between brewing vessels. It is important to note that a CHUGGER PUMP® is not a self-priming pump so DO NOT RUN DRY! The pump head must be flooded with liquid prior to turning on the pump. The CHUGGER PUMP® is also magnetically driven which helps you control the flow rate by adding a ball valve on the discharge side of the pump. This pump can handle liquids of 250F.

General Specification

Model: CPSS-IN-1

Inlet 1/2" MPT Outlet 1/2" MPT

316 STAINLESS STEEL (Front Housing), 316 Stainless Steel (Rear Housing), Teflon (Thrust Washer), CLEAR Silicone (O-Ring), Ryton/Teflon Impeller

Max Flow 7 GPM 22.7 LPM
Max Head 18.6 FT 4.1 M

Power 1/20 HP (.04 HP) .029 KW
Electrical 115V 50/60HZ
Non-Submersible

Motor AMP Rating - Full Load Amps (FLA)
Motor Only: 1.7 Amps
Motor and Pump: 1.9 Amps

Can handle liquids of 250F
Materials are FDA Food Compliant
Components are UL Recognized


Installation

The CHUGGER PUMP® is shipped ready for installation. Directional arrows on the pump head show fluid direction through the pump. The four screws on the pump head may be removed and the pump head can be rotated as required to fit your piping system. Check out "How to Change a Chugger Pump Orientation Video": http://www.chuggerpumps.com/media-center/

The motor should be oiled yearly with 4-5 drops SAE20 weight non-detergent oil, do not over oil.

Follow all local electrical safety codes and always disconnect power before performing work on or near the pump motor.



Limited Warranty

CHUGGER PUMP® is warranted only against defects in workmanship for a period of 6 months from the date of purchase. DO NOT RUN THE PUMP DRY, it will not be covered under warranty. A SQUEALING SOUND IS A WARNING YOU ARE RUNNING THE PUMP WITH NO FLUID!!!! POWER OFF IMMEDIATELY!!! DO NOT PLUMB INLET TUBING OR CONNECTIONS WITH LESS THAN 1/2" FULL PORT FITTINGS. THIS WILL RESULT IN CAVITIATION AND PROBLEMS WITH YOUR PUMP!!!!
Be the first to write a review.  Write a Review.

This product was added to our catalog on Monday 27 October, 2014.



Content

Free Shipping